05-31-2006 04:36 AM - edited 03-10-2019 02:36 PM
hi folks,
is it possible to configure db replication between the ACS 4 appliance & the ACS 4 windows db? any caveats, gotchas or field experience?
would this also work with ACS load balancing, using both the solution engine & the windows db, as long as they're sync'ed?
thanks,
anurag
05-31-2006 06:18 PM
replying to my own query. here's the official word from the ACS team, in case anyone else runs into this:
"Yes you can do replication between the two flavors of ACS as long as they both run the same version.
To drill down, replication between ACS-SE 4.0.1(43) (HP) and ACS-SE 4.0.1(42) (Quanta) and ACS software version 4.0.1(27) was tested is approved and supported."
FYI.
06-01-2006 02:26 AM
.. did you ask them if QA actually tested this?
$10 they didnt ;)
06-01-2006 07:48 AM
no, not really, i didn't think to ask that...maybe i should've :)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide