Network Access Control

I'm trying to upgrade from 3.3.2 to v3.3.4 on a Windows 2000 server (SP4) and everytime I run the update it gives me a message about half way through:"The CiscoSecure ACS folder appears to be locked by another applicationC:\Program Files\CiscoSecure ...

I have a setup where my VPN users hit the ACS server for user authentication - off of AD. What I am not sure of, is how to limit which users have VPN access. All of the users would still need to authenticate for wireless (EAP) but be limited to eit...

Good morning all, Prior to switching to the appliance version of ACS, we had a couple perl scripts that would run to accomplish some accounts management. Have any of you tried to do this since installing the appliances? Also, is there a particular ...

Hi,does ACS 4.1 support EAP-TTLS or not ? As forth as I am informed it does NOT.Am I correct. Thanks.

Hi,I have configured Microsoft CA server on the same ACS 4.0 for Windows 2003 enterprise server which was configured earlier using the self generated certificates for EAP and PEAP authentications.After I change the certificate from self generated to ...

Is it possible to force a virus scan prior to giving acces to the network using nac appliance (with or without cca) ? Also, any way to know when was the last time the machine fully virus scanned ?Thx

Hi List,I installed Cisco ACS 4.1 but when I'm configuring via GUI, suddenly after 5 min, the GUI session is disconnected, and I have to connected again, I don't know why the management session is disconnected if in Administration Control the Session...

folks i have an appliance 1113 v4.0 and suddenly i can't http to iti can console ok but my http username/password just give a protocol errorany idea how to look into this, i.e. is there a log file i can look at for error messagesthanks to anyone taki...

We have two CiscoSecure Server on W2k3.We use Radius from CiscoSecure and an external Rsa Securid Token to authenticate the user (running on the same server). With the ACS 3.3, the authentication works fine ( every state works : new pin mode, next t...

Hi,I had configured C3560 switch running Version 12.2(25)SEB4 to authenticate telnet session against ACS SE 4.1 (Tacacs+).I encountered a problem once I issued the command ** aaa authentication enable default group tacacs+ enable **the enabled passw...

Hi,I have two ACS servers and have been trying unsuccessfully to setup Windows NLB for them. I can successful setup the NLB but ACS won't respond on the clustered IP. Other services running on the clustered IP will respond so I believe the NLB is w...

Hi I think i have a simple question: I wan't do activate 802.1x on our siwtches(about 800 devices: 6500,3500,3600,4500,...). We use for telnet Tacacs for authentication,authorization and accounting. For 802.1x i need to configure raidius on the switc...