10-14-2008 04:07 AM - edited 03-10-2019 04:08 PM
I have configured one client, remote agent and the ACSE. I am able to authenticate into the network device via AD. It prompts me for credentials then I am in user mode. I then issue the enable command to enter privileged mode. It then prompts me to authenticate again. My question is how do I configure ACS to enter me directly into privileged mode once I have successfully authenticated? I do not want to first be in user mode then have to authenticate again to enter privileged mode. Any help would be greatly appreciated. Thank You!
Solved! Go to Solution.
10-14-2008 04:43 AM
Bring users/groups in at level 15
1. Go to user or group setup in ACS
2. Drop down to "TACACS+ Settings"
3. Place a check in "Shell (Exec)"
4. Place a check in "Privilege level" and enter "15" in the adjacent field
Also make sure we have exec authorization enabled.
aaa authorization exec default group tacacs+ if-authenticated
Regards,
~JG
Do rate helpful posts
10-14-2008 04:43 AM
Bring users/groups in at level 15
1. Go to user or group setup in ACS
2. Drop down to "TACACS+ Settings"
3. Place a check in "Shell (Exec)"
4. Place a check in "Privilege level" and enter "15" in the adjacent field
Also make sure we have exec authorization enabled.
aaa authorization exec default group tacacs+ if-authenticated
Regards,
~JG
Do rate helpful posts
10-14-2008 07:59 AM
Right on the money! Thanks for your time!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide