09-17-2007 06:56 AM - edited 03-10-2019 03:23 PM
How can I add a static route to my ACS SE appliance?
I am trying to get AAA working on a Cisco 871 that is a remote end-point of an ASA-to-871 s2s vpn. On the router I am using vlan1 as the source interface for tacacs.
My ACS server sits on my ASA's Management subnet, but the ACS' route back to the remote LAN is via its default gateway and the ASA's INSIDE interface. I need to get the ACS tacacs traffic to return via the ASA management interface.
Thanks in advance.
John
Solved! Go to Solution.
09-17-2007 02:39 PM
John,
There is no way to set a static route in the ACS appliance. The only network parameters you can set are the ip address/subnet, default gateway, and dns servers.
Regards,
~JG
Please mark it resolved so other can benefit from it
09-17-2007 02:39 PM
John,
There is no way to set a static route in the ACS appliance. The only network parameters you can set are the ip address/subnet, default gateway, and dns servers.
Regards,
~JG
Please mark it resolved so other can benefit from it
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide