AnyConnect Posture Internal System Error message

[Theodossis Mantzouratos]

Hello community,

I've got to configure ISE posture with AnyConnect & ASA for remote access VPN and I get the following error message right when system scan tries to contact ISE server for posture checks.

VPN tunnel ok,

DNS resolution ok,

compliance module communicates to policy server,

client provisioning ok.

Wondering, if anyone ever stumbled upon this error and maybe has a tip for what might causing it. I'm unable to find anything on the internet...

-Setup-

ISE v2.4

ASA v9.6.4

Anyconnect v4.7.04056

ISEComppliance module v4.3.723.4353

[Jason Kunst · Accepted solution]

if you can readily reproduce this then open TAC case. its generic and will need the logs looked at. Also this isn't an anyconnect forum

[Theodossis Mantzouratos]

Thanks, I've already done this and solution found! I thought I could start any tech topic (anyconnect included)....

[Jason Kunst]

You’re going to get the better information under the correct community. This is not the AnyConnect community. Not everyone looks at all communities

[dpereziii]

What was your solution? 

[Theodossis Mantzouratos]

It wasn't AnyConnect's fault. The error message came up from ISE server and soon I rebooted the ISE server everything came up normal, no error after that.

[Evanjrosado]

2 of my clients received this same error today during posture attempt. Were running ISE 2.6 patch 6. I'm going to open a TAC case. ISE has been rebooted twice but this problem still occurs.