11-18-2021 10:06 PM
Hello Gents,
I am looking to have the AP 9120AX as EAP-TLS supplicant,
AP#show ap authentication status
AP dot1x feature is disabled.
There is an option to user credentials for the EAP-PEAP.
AP#capwap ap dot1x username user1 password ***
How can the AP be set to user a certificate (EAP-TLS) rather than credentials (PEAP) for authentication.
Thanks,
Solved! Go to Solution.
11-30-2021 02:41 PM
It would help to know which software release you are using next time and if you looked in the configuration guide or not.
I found this with an internet search of "17.6.1 wireless controller configuration guide"
Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide > 802.1x Support > EAP-TLS/EAP-PEAP Protocol
11-18-2021 11:53 PM
Look at the below may help you. (depends on what version of code running ?)
11-30-2021 02:41 PM
It would help to know which software release you are using next time and if you looked in the configuration guide or not.
I found this with an internet search of "17.6.1 wireless controller configuration guide"
Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide > 802.1x Support > EAP-TLS/EAP-PEAP Protocol
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: