cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3703
Views
0
Helpful
2
Replies

APC UPS RADIUS AUTHENTICATION

colbysunday
Level 1
Level 1

I am running 2 PSNs in a PSN group behind F5 load balancer. I've configured RADIUS authentication for several other platforms without issue. When I'm attempting to configure RADIUS authentication for APC network management card 2, I never see the RADIUS request from the NMC2 in the live logs. I did a tcpdump on the F5 and I see the RADIUS access-request but nothing after that and the NMC2 web ui displays invalid user name or password. Anyone else seen anything similar?

1 Accepted Solution

Accepted Solutions

balaji.bandi
Hall of Fame
Hall of Fame

You need to look at APC vendor suggestions on what is to be done on the radius side. ( for me it's MAC-based authentication).

 

https://www.apc.com/us/en/faqs/FA156083/

 

There are some success stories with ACS, but basically, it is the same with ISE.

 

https://community.cisco.com/t5/network-access-control/acs-and-apc-ups-radius-authentication/m-p/985072#M396718

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

View solution in original post

2 Replies 2

balaji.bandi
Hall of Fame
Hall of Fame

You need to look at APC vendor suggestions on what is to be done on the radius side. ( for me it's MAC-based authentication).

 

https://www.apc.com/us/en/faqs/FA156083/

 

There are some success stories with ACS, but basically, it is the same with ISE.

 

https://community.cisco.com/t5/network-access-control/acs-and-apc-ups-radius-authentication/m-p/985072#M396718

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Yes, I've gone through all of the documents...should be pretty straight forward. Doesn't work.