APC UPS RADIUS AUTHENTICATION

[colbysunday]

I am running 2 PSNs in a PSN group behind F5 load balancer. I've configured RADIUS authentication for several other platforms without issue. When I'm attempting to configure RADIUS authentication for APC network management card 2, I never see the RADIUS request from the NMC2 in the live logs. I did a tcpdump on the F5 and I see the RADIUS access-request but nothing after that and the NMC2 web ui displays invalid user name or password. Anyone else seen anything similar?

[balaji.bandi · Accepted solution]

You need to look at APC vendor suggestions on what is to be done on the radius side. ( for me it's MAC-based authentication).

https://www.apc.com/us/en/faqs/FA156083/

There are some success stories with ACS, but basically, it is the same with ISE.

https://community.cisco.com/t5/network-access-control/acs-and-apc-ups-radius-authentication/m-p/985072#M396718

[colbysunday]

Yes, I've gone through all of the documents...should be pretty straight forward. Doesn't work. 

[Mr.Jones]

@colbysunday I'm suffering from the same issue. Did you ever get this working?