- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-05-2021 10:05 AM
I am running 2 PSNs in a PSN group behind F5 load balancer. I've configured RADIUS authentication for several other platforms without issue. When I'm attempting to configure RADIUS authentication for APC network management card 2, I never see the RADIUS request from the NMC2 in the live logs. I did a tcpdump on the F5 and I see the RADIUS access-request but nothing after that and the NMC2 web ui displays invalid user name or password. Anyone else seen anything similar?
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-05-2021 10:52 AM
You need to look at APC vendor suggestions on what is to be done on the radius side. ( for me it's MAC-based authentication).
https://www.apc.com/us/en/faqs/FA156083/
There are some success stories with ACS, but basically, it is the same with ISE.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-05-2021 10:52 AM
You need to look at APC vendor suggestions on what is to be done on the radius side. ( for me it's MAC-based authentication).
https://www.apc.com/us/en/faqs/FA156083/
There are some success stories with ACS, but basically, it is the same with ISE.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-16-2021 05:33 AM
Yes, I've gone through all of the documents...should be pretty straight forward. Doesn't work.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-09-2025 03:35 AM
@colbysunday I'm suffering from the same issue. Did you ever get this working?
