09-15-2023 07:20 AM - edited 09-15-2023 07:21 AM
I plan to apply patch 3 to our 2 nodes ISE 3.2 via CLI
Do I need to apply the patch to each node manually or will the patch be applied to the second node once the first node has been successful.
Solved! Go to Solution.
09-15-2023 10:17 AM
- Using the CLI you always have a 'manual sequence' ; and do each node yourself ; which is recommended .
M.
09-17-2023 01:17 PM
If you patch via the GUI, then the Primary Admin Node is done first, followed by a non-stop sequence that you can't pre-determine yourself. As long as the patching was successful, the patching continues to the next node. Manual patching gives you complete control over the sequence.
09-15-2023 10:17 AM
- Using the CLI you always have a 'manual sequence' ; and do each node yourself ; which is recommended .
M.
09-17-2023 01:17 PM
If you patch via the GUI, then the Primary Admin Node is done first, followed by a non-stop sequence that you can't pre-determine yourself. As long as the patching was successful, the patching continues to the next node. Manual patching gives you complete control over the sequence.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide