Network Access Control

ACS 5.3 Log Collector stopping receive Logs In our deployment, there are 5 appliances and 1 of them is as exclusive Log Collector. Today already for several times, he is stopping to receive logs and other appliances in Dashboard >> ACS Health Status,...

Hi I'm currently trying to setup a dot1x lab environment with a CS ACS 5.4. Now I have the following problem: I'd like to use the command "authentication event server dead action reinitialize vlan 180" if the radius server is dead. On my switch inter...

We're provisioning a 2821 with IOS 15.1(4)M5 ADVSECURITYK9 for Easy VPN/classic client access. Everything works fine with local authentication. When we switch to radius authentication, the router sends the group name to the radius server instead of p...

Hi All,Just started installation of ACS 5.4 & integrated it with AD.My AD tree is very big & DL search from Acs 5.4 take longer time , sometime 5-8 mins for one DL or sometimes it times out.Is their any way we can optimise AD search using internal se...

Our ISE Deployment for wireless only is operating on 1.2.0.899 Patch 3.  We are looking to upgrade to Patch 8.  We plan on testing in a Dev envioronment first, but I was curious what others experience had been with stability in Patch 8?

Anyone have a link to instructions on how to upgrade ISE 1.2 (patch to 1.2.1? The release notes don't mention a new process and the old process gives a SHA error.

After implementing TACACS, one of our routers takes about 8 seconds to response to any CLI command. We have no problems with other devices in the same location with the same AAA configuration. The router is talking to the ACS server (ACS 5.3) and the...

Hi guys,We are testing out ISE1.2 in the lab and are trying to achieve posture compliance assessment and remediation of Windows security patches with Windows clients running the SCCM Agent with SCCM 2012 infrastructure.Can you confirm whether support...

Hello, both server are working ok and they can ping each other, but when I try to add CAS into CAM it says:Failed to add server: Could not connect to 10.10.20.100     Any idea what this problem could be? Regards,

Has anyone had an issue with the advanced eval license triggering the below alerts after a full base license has been installed and the advanced eval license has expired?How can I keep the license expiration warnings and avoid receiving warnings for ...

interface FastEthernet1/0/47 switchport access vlan 4 switchport mode access switchport voice vlan 69 authentication control-direction in authentication event fail action next-method authentication event no-response action authorize vlan 100 authenti...