Network Access Control

Hi all experts .I know its a very common question but pls guide mei have created a username "Support" and want to allow him full view of running configuration and any show command he runs. But he should'nt be able to enter config mode to prevent him ...

Hello,When upgrading from Eval ACS 5.1 to permanent liceense, is it true that all data thats configured on the ACS Server will be removed from the ACS Server?Thanks

Hello,What do i need to do to set up monitoring ACS 5.1. The userguide shows that the folowing commands need to be allowed on the NAD,1.logging monitor informational2.logging origin-id ip3.logging host logging host ip transport udp port 20514—where i...

Hi every bodyi want to downgrade ACS engine, migrate from ACS V5 to ACS V4please, any one can help me

Hi every bodyi have to configure ACS5.0.1 engine with wlc 2125 for wireless users authenticationi'm not familar with acs 5.0.1, please i need helpthank's

Hi,I am trying to upgrade ACS in Windows 3.0 to ACS 4.1.I want to know the steps which are required to do this migration and secondly when i tried it before it keep on saying not enough disk space enough though i have 25GB of hard-disk.I want to back...

Hello Everyone,I am doing a last minute install/demo  of the Cisco ACS System 5.1 on a vmware machine. I am totally unfamiliar with this product. Can anyone provide some good links on this product which will make my life easier when I do this in fron...

I'm trying to setup a wireless network using cisco 1240AG access points (for AAA clients) and Cisco ACS 3.3 for the AAA server and Active Directory for authentication. Wireless laptops are able to communicate with the access points and the ACS but I ...

Hello EveryoneI have gotten into a bit of difficulty when  configuring Command sets on the ACS. I have put commands on the ACS and  configured aaa authorization commands on the Cisco Device.. It does work  but "access-list" command and other commands...

Hi There, I am trying to setup command authorization in ACS 4.2.1.15 but its partially working.I have setup three sets of shell command ... full access is working fine. another one is read only which is causing problem. in this command set I have all...