Network Access Control

Need to upgrade Cisco ACS SE 1111 and 1112.Currently running platform 4.1.1.23.5 and need a to upgrade to 4.1.4.13.14Do I need an upgrade CD for 4.1.4.13 and the recovery Disk? If so do I need different version CDs for SE Hardware 1111 and 1112?If CD...

We're using ACS 1113 Appliance with ACS version 4.1.4.13. via the RADIUS attributes, clients are re-authenticated every 16 hours. The machine cache is set to 12 hours. This means that, if the user doesn't log off within 16 hours, he will be denied ne...

Hi,we want to rebuilt our design. In the future we want to have 4 ACS server behind a pair of load balancer. Does anybody knows whether the ASC server works with a load balancer.thanks for your answers.Torsten Waibel

We have quite a few ASA s with similar tacacs and crypto configs but yesterday we had issue with pix and we swapped pix with ASA 8.0(3) and tunnel is up and running but we are not able to login using tacacs even after the configs,, and i found a bug ...

We recently encountered problems with the database replication of our ACS servers -- Server1 and Server2 (separate location). The last successful replication was last midnight of 02/22/2009 and started to fail at around 18:17 hours of the same date.H...

i have reset the ACS Appliance, after that i cannot set the IP address. it return error when i try to set the IP address. any solution?

hi all, i applied following command "privilege interface level 6 vlan-range" but not able to c any sub-commands when i reach... conf t--interface gig x/y--vlan-range-- only "no" is there. Any clues

Hi,we want to automatically sychronize our ACS server with an external database including user, groups, network devices and command authorization sets. As read in the RDBMS sychronization import definitions there is no possibility to import "command ...

Hi All, I have the following situation. I need to configure two ACS appliances to authenticate remote users that connect via VPN, against an AD server.In other words, the remote users connect with their VPN clients to an ASA (which then send the requ...

Our US counterpart has shipped the Pix Firewall 506E to us. I need a picture of it so that I can do a customs pre-declaration before it arrives. Could you provide me the picture.

Hello,I would like to configure Dot1x authentication on each switch interface that belongs to data and voice vlan such as for eg:Interface FastEthernet 1/1switchport access vlan 10switchport voice vlan 20But it is not allowed to configure Dot1x on th...