Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all,Does everyone has an idea on how to activate "per-packet load sharing" on a 7606S with RSP720-3CXL engine and 7600-ES+20G3CXL module.The IOS version is : 7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRD4, RELEASE SOFTWARE (fc2)I tried...
Dear all,Does everyone has an idea on how to activate "per-packet load sharing" on a 7606S with RSP720-3CXL engine and 7600-ES+20G3CXL module.The IOS version is : 7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRD4, RELEASE SOFTWARE (fc2)I tried...
Dear all,Does everyone has an idea on how to activate "per-packet load sharing" on a 7606S with RSP720-3CXL engine and 7600-ES+20G3CXL module.The IOS version is : 7600rsp72043_rp-ADVIPSERVICESK9-M), Version 12.2(33)SRD4, RELEASE SOFTWARE (fc2)I tried...
Hi everyone,We are currently migrating our network from IP to MPLS and we encounter an issue with a only one application using security certificat through HTTPS. All other services are OK such as HTTP, FTP, Mailing, etc. Network description :The netw...
Dear all,We are facing a problem installing a WS-X6724-SFP with DFC3C on a 7606-s / RSP720-GE with DFC3CXL, once the interface module is inserted it is immediately powered down by the router.And we get the following warning message.Module 2 DFC insta...
Atif,This what we are using now. But we tried on a 7300 lab, and the load-share was achieved by using per-packet load-balancing.Using per-destination method does not allow to have a different trafic volume forwarding on the interfaces.But we will try...
Hi Atif,Thanks for you reply. It's really damage as we need absolutely to perform a per-packet load sharing on our 7606S routers as a part of an MPLS-TE.We have four (4) inequal bandwidth links and need to forward paket with ratios.Thanks.
Hi Serge,I saw your post after lot of search about this problem of packtried et loss when using PBR.We face the similar problem on our IP/MPLS Backbone, several solutions but no success.So I'd like to know if you finally found the solution of this pr...
Hi Francisco,Thanks for your prompt feed back.But how to do this TCAM table programing ?The command platform ipv4 pbr optimize tcam supported ?Pleas advise.
