Network Access Control

I have config this config for ssh on a Cisco routerline vty 0 4login localtransport input sshBut when I run the show ssh I got following output%No SSHv2 server connections running.I'm happy for any suggestions, thanks 

Today, in our network, ISE is joined to CorporateAD and Corporate user and machine is authenticated using CoporateAD as external ID store and then Posture assessment is done to allow network access. We are implementing NAC for Non-Corporate Users (Wi...

Team,I have 2 questions on the ISE: 1. When we talk about “GigabitEthernet 0”, which port does it map to on the ISE 3515 diagram below.    Is it port number 4? And then what about “GigabitEthernet 1”?    Please refer to the below diagram:       2. Ca...

Hi, A customer of ours has asked if we use Java in ISE. If Java use is version dependent, this customer runs ISE 2.4. Any guidance?Thanks. Best. Kurt

Hi All,We have a requirement to change Acceptable User Policy page button colors.How do we change the color of the sponsored guest portal AUP page "Accept", and "Decline" button colors and text color?ThanksG 

The SNS-3695 is built with 8x 600 GB 10k hard drives, and for a PSN I feel that is fine. Has there been any thought put in to offering an option to replace these drives with SSD's?  The primary use case I have in mind is for the monitoring nodes.  Si...

I am getting reports that the serial console in 36XX appliances does not work.   Datasheet says that appliance has a serial connector but 36XX installation guide has removed the following section that is present in 35XX installation guide: -- snip --...

    Hi Everyone,    I have a question since I am deploying 802.1x port based security feature on CAT 29600 and following is the existing config with port-security enabled on the interface. Can I configure  multi-auth for host mode on the interface ? ...

Hello,   This is regarding posture polcies in SDA environment, DO we need to create a seperate SGT for unknown posture, and restrict access using trustsec policies or the Non SDA approach would still work i.e restricting the access using DACL's.

  Hello, Can anyone please unicast me if the new ISE Base license is calculated based on the qty/nr of endpoints or network type ( wired / wireless)   Customer has 100 Wireless endpoints and 200 wired endpoints   Q: How many licenses are required 300...

We use the Cisco ACS (and now ISE) Tacacs server for more than 12 years. We have too many tacacs accounts. I am sure that a lot of them are no more used. I would like to get the list of the accounts (identities) which have not been used for a long ti...

I've been able to successfully configure and test CWA Chaining after authenticating to ISE via Dot1x (User Auth) then logging into a ISE Guest Portal through CWA flow to enforce the Active Directory group membership for the same or different user acc...