Network Access Control

Hi, How can you determine which TrustSec version is associated with a particular ISE version? For example. If I am running ISE version 2.2, what TrustSec version is associated with that version of ISE? TrustSec 6.1? 6.2?   The reason for asking is if...

Hi everyone,I am implementing Cisco ISE 2.4 in LAB environment with a 2960S switch. I am trying to apply a default ACL on access ports to allow DNS and DC access before dot1x authentication. Unfortunately, the existing image does not support port-bas...

Hey everyone, Happy New Year!My question has to do with Windows Machine Authentication.  I understand the in's and out's of how 802.1x works but having some confusion about the actual authentication of the machine.  My understanding is, when a machin...

Hi to All, i was looking in the ip device tracking command trying to find a use - outside off course of its use with ISE and dACLs. I use a mix environment with some clients having static IP addresses and some other clients having dhcp based ip addre...

how to enable on ISE 802.1X authentication with 3850 and 3650 to push interface command "power inline never" 

Hello, I am just beginning my venture down the DOT1X path and I have been using this community for most if not all of my information gathering.  I am now running into a question that I would like to see the community weigh in on:   Use Cisco Common C...

I am testing a critical auth VLAN config but it looks like I it is not working. The port has a phone and then a PC attached to the phone. Config is below. What happens is that the PC will still get an IP on VLAN 429 (even after ipconfig renew or port...

Hi Team,   Is there an ETA when to expect Base licensing to be term based?   Thank you!

Hi all, An FlexConnect AP is authenticated via 3650/3850 SW 16.x against ISE 2.3 with multi-host mode and there is the default ACL on the interface allowing only DHCP/DNS traffic before succesfull AuthC/AuhtZ. Is it possible to allow any communicatio...

Currently customers SOA server accepts the data in JSON format and below is the sample format that their server can accept : POST https://<<IP>>:<<PORT>>/ENS/v1/SMS HTTP/1.1Accept-Encoding: gzip,deflate [Required, constant]APIKEY: XYZ12345 [Required,...

Hi, I run ISE 1.3 for Wireless, I will be creating a new SSID on my WLC's for a specific amount of users who will be authorised by MAC authentication using ISE.   Basically I will have a list of about 50 mac addresses that will be held on the ISE. Us...

I want to upgrade the ACS from ACS 5.6 to ACS 5.8. Current Version: 5.6.0.22.5 Plan Upgrade to ACS_5.8.0.32.tar.gz Patch 5-8-0-32-10.tar.gpg I know there are additional steps involved- like de-register, change the log server, and so on. I just want t...

helloi have ise 2.0  and mse 8.0.150.0 , when i add MSE to ISE i get this error ."No response. Network error or invalid IP address"  i completed all of the configuration about Cisco prime , WLC and MSE . all of them working and no problem with each o...

Hello folks,I wonder what I have to do in ISE to enable it sending SMS when activating a new guest account. I believe there must be a corresponding setting somewhere under Web Portal Management to configure SMS gateway neither under Global system set...

Hello All,   An IP Phone is coonected to a switch port enabled for ISE authentication. IP device tracking autosource is enabled, but still we are not able to see the IP address while doing "sh auth sessions" on the switch. Could anyone please help me...