cannot reset-config as APP_START is running v3.1

[moha99edhamedan]

Hello,
I am not able to perform any changes in ise
adding ip or delete 
reset-config 
start/stop application ise 
whenever I tried the following message appeared 

waiting up to 30 seconds for APP_START to finish 
cannot continue ip address change as APP_START is running 

I tried rebooting the node but the same problem 

[balaji.bandi]

It would help if you waited for some time to app start to finish before you config., Depending on compute it will take some time.

check the application running from console :

#show application status ise
# application stop ise
check again 
#show application status ise

[moha99edhamedan]

Thank you for your reply balaji ,
i tried to report the node and waited for 12 hours and still the same error appered 

[Milos_Jovanovic]

Hi @moha99edhamedan,

12hrs is not regular time to start ISE It usually takes 5-15 mins, depending on the HW. I would assume it is either broken, or initially installed faulty. Either way, I would proceed with re-image of the node.

Kind regards,

Milos

[thomas · Accepted solution]

I don't see any followups from you after a few weeks so I will assume restarts worked or you called TAC to resolve.