Changing Date/Time(zone) on ACS5.1

[WizardofCOR]

Would love to know where I can change the date/time(zone) within ACS v5.1.  Changing it in the BIOS doesn't have a zone option, just date/time.  ACS then displays something completely different upon boot.  Haven't been able to find any settings for this in the GUI, and the one link I did find in a discussion points to a doc that apparently I'd need special access for.

Attempting to join this to AD, so instructions on setting up the NTP server would also be helpful.

None of these options were available during the clean setup of 5.1.

Thanks much!

[Federico Ziliotto · Accepted solution]

Hi Wayne,

This can be done through the command line over a console/SSH connection.

1. To manually set the clock:
http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.1/command/reference/cli_app_a.html#wp1036987

2. To configure an NTP server:
http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.1/command/reference/cli_app_a.html#wp1013780

3. To configure the time zone:
http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_system/5.1/command/reference/cli_app_a.html#wp1013028

Hope this helps,

Fede

--
If  this helps you and/or answers your question please mark the question as  "answered" and/or rate it, so other users can easily find it.

[WizardofCOR]

Thank you, Fede - That was exactly what I needed.  =)

5 stars, and "answered".

[Federico Ziliotto]

Thank you Wayne, glad this helped.

Feel free to ping us back in the future in case further assistance would be needed with your ACS.

Regards,

Fede

--

If  this helps you and/or answers your question please mark the question as  "answered" and/or rate it, so other users can easily find it.

[Manivannan R]

Hi fziliott,

      Thank you so much, can you please tell us what impact will happen while changing time zone in ACS 5.5 in live network.