Hi guys,
I am having a problem with our RADIUS and some new 1000v Switches. The issue is, the switches are not sending a NAS ID, this is required by the policy server. All our other cisco devices are workign fine, I can see the rror too, Is there any workaroudn for this:
debug:
radius: radius_update_request_state_for_server(1490): Using IP 0.0.0.0 as NAS IP.
radius: radius_update_request_state_for_server(1502): Can not find the source IP for destination IP *SERVERIP* to populate the NAS IP.
The device has only 1 Ip address, on the mgmt0 interface in a VRF called "management"
config:
ip radius source-interface mgmt0
radius-server host xxx key 7 "xxx" auth-port 1645 acct-port 1646 authentication accounting
radius-server host xxx key 7 "xxx" auth-port 1645 acct-port 1646 authentication accounting
aaa group server radius RADIUSAUTH
server xxx
server xxx
use-vrf management
source-interface mgmt0
aaa authentication login default group RADIUSAUTH local
aaa accounting default group RADIUSAUTH
I have also tried these commands:
radius-server directed-request
aaa authentication login ascii-authentication
But it has not helped. Without a NAS ID the auth server will not process the request.
