Cisco ACS config file

[cm6043]

Hi all,

I have a cisco ACS V.4.0 server and want to get the config file. How can I get the CLI command prompt ? Or, Any where I can get the config file ?

Thanks

Leung Che Man

[Jatin Katyal]

You can always take ACS backup from the GUI by going to System Configuration >>  Click ACS Backup >> enter the FTP information >> Backup now.

Performing a Manual ACS Backup

http://www.cisco.com/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_windows/4.0/user/guide/sba.html#wp222516

Once you connected to ACS via CLI the default username and password if not changed would be
user= Administrator
Pass= setup

Establishing a Serial Console Connection

http://cisco.biz/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.0/installation/guide/appliance/instalap.html#wpxref17544

Backing Up ACS Data From the Serial Console

http://cisco.biz/en/US/docs/net_mgmt/cisco_secure_access_control_server_for_solution_engine/4.0/installation/guide/appliance/admap.html#wp1057928

Regds,

JK

Do rate helpful posts-

[cm6043]

Hi jkatyal,

Thanks for your information. Could I get CLI prompt remotely ?

Thanks

Leung che Man

[Jatin Katyal · Accepted solution]

Unfortunately, that is not supported. You've to connect to ACS via hyperterminal using console cable.

Regds,

JK

Do rate helpul posts-