Cisco ISE 2.4 - HP Comware Wired 802.1X

[Leonardo Pena Aristizabal]

Hello Community,

I have a customer that wants to integrate their LAN network based on HP Switch's with the Cisco ISE on version 2.4, but for some reason the users get disconnected randomly, what I see in the logs is attached.

What I have done until now is:

1. Play with the device profile (HPWired - Cisco - HP SNMP CoA).

2. Attribute Setting -  Session-Timeout = 1800

3. Peap Settings - Enable PEAP Session Resume (7,200)

4. Disable all allowed protocols except PEAP, PEAP Fast - EAP-MS-CHAPv2

Attached is the config of the SW HP also.

I see a strange behaviour in the ISE Logs:

Jan 16, 2019 06:22:30.009 PM	USERNAME	AA:8E:38:B5:37:B1	802.1X_LAN_P	802.1X_LAN_P	Mo	slot=1;subslot=0;port=20;vlanid=217	PRDPVLPBD
Jan 16, 2019 06:22:30.006 PM	host/EXTESCG2.p	AA:8E:38:B5:37:B1

Thanks for you time.

[Timothy Abbott]

It is possible the switch is not respecting the session timeout attribute.  Have you tried configuring it on the switch interface?

Regards,

-Tim

[Leonardo Pena Aristizabal]

Thanks for yor reply, but the only command supported in the interface is this:

[CYMAISE-Ethernet1/0/2]dot1x re-authenticate ?
  <cr>

And is already configured.

[Ruelb2214]

I had the same problem with HPE Comware Software, Version 7.1.070, Release 3507

Switch Model : HPE 5130 48G 

were you able to solve the problem? can you share the solution please...

thanks!

[AamirSohail7861]

Facing exactly the same issue... Is anyone able to solve it?