Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I'm integrating WLC to CMX setup, both installation is successful but during the integration using the setup assistant in CMX it's asking for mail server setting but I don't have SMTP server since this is setup only in test environment.The inte...
Hi,I been using PEAP for endpoints authentication in our infra, we authenticate machine + user ID to grant access on network and no issue.Recently we needed to change to EAP-TLS method, by using the same certificate in ISE which is working with PEAP...
Hi,We recently purchase 2xSNS-3755-K9 appliance, and it comes with version 3.2 then we patch it until patch 7 version.Then we want to upgrade to version 3.3, health checks all GREEN but we face the issue:"Unable to unbundle the package. It should be ...
Hi ALL,We suddenly encounter issue on Wired connection with ISE, but on wireless no issue at all.Every time laptop authenticates on wired, we got these logs from ISE:Failure Reason :12953 Received EAP packet from the middle of conversation that conta...
Hi ALL,We have ASA running in firepower-2130, recently we upgraded to version cisco-asa-fp2k.9.18.4.40.SPA, the upgrade was smooth,but we encounter crypto graphic error, similar to attached.Then when I check the commands for "crypto ikev2 policy" the...
I manage to synch WLC to CMX by adding it manually in CLI. attached the status.But what I notice is the AP is not synch in CMX only the floor plan.This is another problem I'm facing hopefully someone can share how to fix.I'm following this guide, but...
Hi @Mark Elsen I tried to add manually the WLC, but as you can see on the screenshots attached it's not connected.CMX version 11.1.0-21 9800 CL version 17.15.3
finally manage to find the root cause when I did wire shark capture.The issue was the setting on the machine cert, the application setting was set to server auth instead of client auth.Thank you guys for your response.
Just to add in, if I configure PEAP on supplicant or endpoint, on the debug logs we are able to see the HOST\ attribute when machine authenticate. From this instance I can say there's no issue on the certificate itself.Please enlighten me what could ...
