Solved: Re: Cisco ISE 3.2v Patch 7 installation

Siyadh34 · ‎11-24-2023

Hi All,

We are planning to install Patch 7 on Cisco ISE v3.2.

Are there any issues found in Patch 7 for RADIUS - Dot1x authentication (EAP-TLS) & Posture Services?

If anyone installed patch 7 in ISE 3.2 and faced any bugs and issues in ISE authentication & Posture services or faced any other issues, please let me know.

Thanks!!

Marcelo Morais · ‎12-21-2023

Hi @Siyadh34 ,

ISE 3.1 P8 was released on Dec 5th, it's a new patch !!!

Open Caveats on 3.1 P8 (as an example):

CSCwf69715 After patch install TC-NAC adapters will be not reachable and new adapters cannot be configured

Fixed issues on 3.1 P8 (as an example)

CSCwi06794 Live log delay (RADIUS) - Regression for CSCwe00424

Hope this helps !!!

View solution in original post

adamscottmaster2013 · ‎11-24-2023

@Siyadh34: you mean 3.1 patch-7 right? Because the latest patch for 3.2 version is patch-4.

I only use 3.1 patch-7 for radius/tacacs+ device administration so I can't comment specifically on the dot1x but I use version 3.2 patch-4 andit seems to be ok so far. I would say that 3.1 patch-7 is a very stable version, IMHO, because it was released in May '23 and Cisco has not released patch-8 for almost six months. Normally, I would see a new patch release every three to four months. YMMV.

Siyadh34 · ‎12-21-2023

Hi Adam,

Recently the patch 8 has been released by cisco for ISE v3.1.

May I know any bugs or issues are there in patch 8?

If yes, please let me know the resolutions for the findings.

Thank you!

Arne Bier · ‎11-26-2023

I also haven't seen any noticeable bugs with 3.1 p7. 802.1X been running stable for many months. I don't have any Posture requirements though.

Siyadh34 · ‎12-21-2023

Hi Arne,