Cisco ISE add With DNAC

[longdv]

Hi everyone
I need to add ISE with DNAC now but have some questions
1. Cisco ISE add with DNAC with which Port at DNAC and ISE?
2. ISE Eth1 Port is Copper Port so I want to use MGMT and ISE Port 2, 3 will be Data Port. Now, can I change Default Gateway Port during Setup?

[longdv]

update topology

[balaji.bandi]

ISE CIMC is different and Management port is different look hardware installation guide :

https://www.cisco.com/c/en/us/td/docs/security/ise/sns3600hig/b_sns_3600_install/b_sns_3600_install_chapter_00.html

Refer DNAC and ISE Integration :

https://community.cisco.com/t5/networking-knowledge-base/how-to-cisco-dna-center-ise-integration/ta-p/3896410

They required IP reachability for them to join each other.

[longdv]

Hi @balaji.bandi 

My idea is to configure Data Port ISE (with MGMT) through Eth2 and Eth3 ports and skip Eth0, Eth1
Is it possible?

[balaji.bandi]

have you looked the document i was referred has that information what ports to avoided and used for :

any way below information specific for your question.

https://www.cisco.com/c/en/us/td/docs/security/ise/3-0/install_guide/b_ise_InstallationGuide30/b_ise_InstallationGuide30_chapter_7.html

[Rob Ingram]

@longdv you cannot skip Eth0, ISE management is restricted to Gigabit Ethernet 0 (or could be a bond with Eth0 + Eth1)

https://www.cisco.com/c/en/us/td/docs/security/ise/3-1/install_guide/b_ise_InstallationGuide31/b_ise_InstallationGuide31_chapter_7.html

[longdv]

I'm using hardware Cisco ISE :  SNS-3755-K9