09-15-2023 07:21 AM
Hi
I ran into the bug below after upgrading to ISE ver 2.7 last year. "External RADIUS Server" list is blank but previously added external Radius servers can be seen under "RADIUS Server Sequences"
https://bst.cisco.com/bugsearch/bug/CSCwb04566
The bug has been updated with a link to the one below suggesting that this is fixed in 3.x. i've upgraded to 3.2 patch 3 and the issue is still present. Does anyone know of a workaround for this?
https://bst.cisco.com/bugsearch/bug/CSCwb01854
thanks
Andy
Solved! Go to Solution.
09-18-2023 02:52 AM
Hello,
I ran this issue few weeks ago.
I had to open a TAC case since it's an issue that could be resolved only via accessing the ISE Database.
09-15-2023 07:36 AM
Interestingly, I get the following message when I open one of the exisitng RADIUS Server Sequences. I don't recall seeing that on ver 2.7. Will contact TAC again about this.
Andy
xwt.widget.repeater.DataRepeater._fetchItem(). A record(record id='onRequestRepeater') in your data store does not contain a field named 'valueChanged' but it is defined in the structure of the repeater.
09-18-2023 02:52 AM
Hello,
I ran this issue few weeks ago.
I had to open a TAC case since it's an issue that could be resolved only via accessing the ISE Database.
09-18-2023 03:45 AM
Thanks for that. I've contacted our Cisco partner to raise a TAC case - will keep thread updated with any progress.
Andy
10-13-2023 01:45 AM
Contacted TAC who applied the workaround for this.
They added a "dummy" External Radius Server from the gui. From root access, they modified the dummy server before deleting it and commiting the changes to the database.
After that, the already configured External Radius Servers appeared in the ISE GUI allowing me to make changes to them.
11-20-2023 01:36 AM
TAC have opened a new bug for this issue - https://bst.cloudapps.cisco.com/bugsearch/bug/CSCwi18005
Symptom: - External radius server list does not show up on ISE 3.2. - If you try to create a condition you will see the servers listed but not on the External Servers list.
Conditions: - ISE 3.2 - Upgrading to 3.2 using CLI or GUI method - Your ISE 2.7 did not show up External radius server list either
Workaround: open TAC case
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: