10-07-2019 07:46 AM
Hello team, I purchased two Cisco SNS-3615 for my end customer and in the BOM I have this option "SW-36X5-ISE-K9(Cisco ISE Software Load on SNS-36x5-K9 appliance) and want to confirm if the software is already loaded on the appliance or I have to download on software website for deployment?
Please waiting for your feedback.
Best Regards.
Solved! Go to Solution.
10-07-2019 08:12 AM
10-07-2019 08:23 AM
10-07-2019 08:12 AM
10-07-2019 08:23 AM
10-07-2019 08:52 AM
Thanks Jason, very helpfull
10-07-2019 08:50 AM
02-12-2020 09:30 AM
02-12-2020 11:20 PM
Hello Jessie,
In my knowledge all Cisco SNS-36X5-K9 comes with ISE already installed on it all you need is to apply the initial config to help you have control of device and deploy your solution as needed. You'll need below informations for initial setup
- IP Address
- DNS information
- NTP information
- Admins credentials.
- Etc.
But if you have any doubt you can confirm with your support or reseller.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide