Cisco VPN Client and Smartcard Authentication to a Cisco PIX Version 6.3(5)

[rene.schmid]

Hi all,

we are testing a VPN communication between a Cisco VPN Client and a PIX 515E.

We have configured the firewall like the sample config in the url below.

http://www.cisco.com/warp/public/471/configipsecsmart.html

We are using Axalto Cyberflex 32K Smartcards and Axalto Cyberflex e-gate 32K USB Smartcards and USB Tokens. We can not establish a VPN tunnel. In the sample config, they are using a aladdin e-token and a internal windows 2000 CA. We are using Axalto Smartcards and a internal windows 2003 CA. Are there any problems with axalto Smartcards? I haven't found a documentation about axalto and cisco VPN Client.

Any informations will be very helpful.

Thanks for help.

Rene

[thomas.chen]

1. Use 4.6 version of the VPN Client. All versions prior to 4.6 have this problem.

2. Add a rule in the Microsoft firewall to allow UDP port 62515. This can be done by:

- By entering the following command from a DOS prompt - netsh fi add port UDP 62515 "Cisco VPN Service" enable all