How to configure the switch port connect to Meraki AP?

[victor_yc]

Hi, 

We are using cisco 3560x switch, then connect Meraki MR34 Access port for ISE 2.3 project.

For the switch interface between 3560x switch and Meraki AP,if I enable dot1.x and MAB on this interface, I always have lots COA failure messages. If disable dot1.x and MAB, the looks COA failure disappeared. (maybe it is a bug,i do not have time to log case at moment)

If disable dot1.x MAB on this interface, when  "show auth session", i can not see any information.

so, what is the best configuration for this interface?

thanks

[victor_yc]

just found that:

1. if use multi-auth on the interface, i can see all auth session.

2. if use multi-host on the interface, i can not see other devices auth sess on this AP.

but Multiple-authentication mode is limited to eight authentications (hosts) per port.

what is best configure for the switch port connect to Meraki AP? thanks.