How to enable on Cisco ISE 3.1 "Power Supply" trap

[ryosaeba86]

Hi,

I have a Radius Ise 3.1 on Cisco physical server (no VM). The server has 2 PSUs. Now I need to receive a trap for the Power Supply when it goes down. But I can't configure it. There is the possibility to configure multiple traps for Cisco ISE.
The SNMP configuration is as follows:

snmp-server enable
snmp-server trap dskThresholdLimit "75"
snmp-server host 172.27.1.25 version 2c syl_public
snmp-server community syl_public ro
snmp-server engineID WZP2551038V

I get the Default traps like "Link Up" and "Link Down" but not the one relating to the power supply.

Thanks.

[Greg Gibbs]

The ISE traps only provide information that the application can see. Hardware faults are not seen by the ISE application and would therefore need to be monitored from the underlying UCS C-Series server upon which the SNS platform is built.

See the MIB Reference for Cisco UCS Standalone C-Series Servers document for more information.