Hi All,
My question is very simple... after the EOL of the wireless systems based on AireOS software (WLC 5508 & 5520) is there a minimum inter-operability release between these old systems and the new FireOS (WLC 9800 series)?
I need to guarantee se...
Hi,
I have a Radius Ise 3.1 on Cisco physical server (no VM). The server has 2 PSUs. Now I need to receive a trap for the Power Supply when it goes down. But I can't configure it. There is the possibility to configure multiple traps for Cisco ISE.The...
Hi, within a ring topology with REP protocol I have to insert 3 new switches. At the moment the ring has an "Open REP" type configuration, the 2 edge switches PC1 and PC2 are connected to each other but the REP does not run on this link.Here the rep ...
Hi all,my question does not concern the configuration of the device but I need technical information regarding the power supply connector that have be inserted into the AP to power it.Basically I need to know what kind of connector it is. is it possi...
Hi all, I am trying to join a C9115AXI-E AP to the C9800-CL controller with no success ... 69 Outdoor APs (AIR-AP1542I-E-K9) are already associated with this controller (the MAC addresses have been entered as trust devices). Unfortunately with the in...
Hi, I have another question about this topic...
Can you confirm that the WGB Client needs to be compatible about IOS with the AP IOS ?
My doubt is.. in order for a wgb client to be compatible with the rest of the installed APs, I must rightly check i...
Hi,
I want to better describe my problem.The environment is the metro railway one where Interl-WLC L2 Roaming is performed between Client and AP.The following devices are currently installed:
WLC 1 and 2
AIR-CTW5508-K9
8.0.152.12
WLC 3 and 4
AIR...
Maybe I did not explain it clear enough.I know this is the model (it's written in the title).I am only looking for the coaxial connector .. but to buy it I need the technical specifications.Thanks,
