
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-03-2020 06:51 AM
Hi ,
I have switches running IOS XE 03.10.02.E but it has no sh auth br.
Wht command shld i use to display sh auth session, sh auth br, sh dot1x?
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2020 07:55 AM
You can use 'show access-session' command in place of 'show authentication'.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2020 12:18 AM
On IOS XE 03.10.02.E, we can use the same old command to check the authentication session:
Show authentication sessions interface <> details
show authentication sessions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2020 01:18 AM
Hi,
There isnt' any auth cmd. Seems IOS-XE Software doesnt hv auth cmd.
PSF001#sh au?
audit auto
PSF001#sh auth?
% Unrecognized command
PSF001#sh version
Cisco IOS Software, IOS-XE Software, Catalyst 4500 L3 Switch Software (cat4500es8-UNIVERSALK9-M), Version 03.10.02.E RELEASE SOFTWARE (fc4)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2020 02:27 AM

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2020 06:19 AM
Hi,
aaa new-model is present.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
06-04-2020 07:55 AM
You can use 'show access-session' command in place of 'show authentication'.
