This community is for technical, feature, configuration and deployment questions.
For production deployment issues, please contact the TAC!
We will not comment or assist with your TAC case in these forums.
Please see How to Ask the Community for Help for other best practices.
I am having a similar issue to the above bug. I am running ISE 2.3 patch 1. When I try to run the URT, i get a certificate error and it stops running. Will this effect the patch and upgrade process?
Solved! Go to Solution.
I was running ISE 2.4 patch 1. I could not delete a certificate out. It was causing the URT to fail. I went ahead and applied patch 5. The reason I did not contact TAC was the bug is listed as a low priority. If the bug is a low priority, it must not be causing too many real issues with operation or upgrading (that is my logic). The patch installed successfully. After the patch was complete, the suspect certificate is gone as well.
I was running ISE 2.4 patch 1. I could not delete a certificate out. It was causing the URT to fail. I went ahead and applied patch 5. The reason I did not contact TAC was the bug is listed as a low priority. If the bug is a low priority, it must not be causing too many real issues with operation or upgrading (that is my logic). The patch installed successfully. After the patch was complete, the suspect certificate is gone as well.
Adding patch 5 worked. It gave me information on where to remove the certificate, from Syslog targets, I changed cert and could proceed with the 2.6 upgrade.