04-04-2019 05:28 PM
Hi All,
I’m hoping someone can shed some light on this for me. I am attempting to get our lab infrastructure configured to support MUD enabled endpoints. To do this I am navigating to Work Centers -> Profiler -> Settings and check the box against ‘Enable profiling for MUD’. What I am finding is that when I navigate away from this page, and then back to it, the ‘Enable Profiling for MUD’ box is un-checked. I can’t seem to enable this feature. I’m not sure if this is a cosmetic GUI issue or not. I have attached two screenshots to show what I am seeing (before and after). I have tested with both Chrome and Firefox, so I don’t think it’s a browser issue. Has anyone seen behaviour before? Am I missing a step somewhere?
Thanks in advance
Brad
Solved! Go to Solution.
04-17-2019 04:51 PM
Assuming yours an upgraded ISE setup, this looks like a bug associated with ISE upgrade. I just open CSCvp37981
04-17-2019 04:51 PM
Assuming yours an upgraded ISE setup, this looks like a bug associated with ISE upgrade. I just open CSCvp37981
04-17-2019 06:29 PM
Thanks for responding. Yes, it was an upgrade from ISE 2.4.
05-02-2019 07:26 AM
This issue is not seen when you install 2.6 fresh (not upgraded)
For now, please use a fresh install of 2.6 for Configuring Mud.
We are investigating the upgrade path.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide