ISE 2.6 Factory reset

[LAN team]

Hello,

I want to factory reset an ISE node.

During the "application reset-config ise" an admin/password setting is requested.

And I want to have the ISE node ready to be setup by someone who will not have the admin/password credential as if it was a new shipped device from Cisco.

And without need to re-image the server.

Any advice please ?

Thank you.

[balaji.bandi · Accepted solution]

that how the reset works :

https://www.cisco.com/c/en/us/td/docs/security/ise/2-7/cli_guide/b_ise_CLIReferenceGuide_27/b_ise_CLIReferenceGuide_27_chapter_01.html#wp1727183819

if you do not like and you like facotry setup : re-image only option you have.

https://www.cisco.com/c/en/us/td/docs/security/ise/2-4/install_guide/b_ise_InstallationGuide24/b_ise_InstallationGuide24_chapter_011.html#id_70768