cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1255
Views
5
Helpful
3
Replies

ISE AnyConnect Posture / DNS issue

Dears , 

I need your help with my problem , 

As you know almost all Client want to using internet while they are using anyconnect session . this is operated normally by adding split-tunnel to the configuration . 

But when I configure anyconnect posture my problem is appear . the PCs is required DNS with ability to resolved ISE hostname .
I solved the problem temporary by add static DNS record to my PC but it's  unscalable method  .
Does anyone  have another way to avoid this limitation ? 

note : I already push my private  DNS  information with AnyConnect configuration 
           I mean the AnyConnect  Client  received IP  Address , Split-Tunnel and DNS .

1 Accepted Solution

Accepted Solutions

Mike.Cifelli
VIP Alumni
VIP Alumni
Please share the contents of your redirect acl you use when posture status is unknown. Should look something like this:
Extended IP access list ISE_REDIRECT
deny ip any host <ISE>
deny udp any any eq domain
permit ip any any
The logic is flipped. Good luck & HTH!

View solution in original post

3 Replies 3

Mike.Cifelli
VIP Alumni
VIP Alumni
Please share the contents of your redirect acl you use when posture status is unknown. Should look something like this:
Extended IP access list ISE_REDIRECT
deny ip any host <ISE>
deny udp any any eq domain
permit ip any any
The logic is flipped. Good luck & HTH!

Dear Mike 

First of all I do apologize for the delay because i was outside my office  , 

Please find the below Redirect ACL ( in ASA ) 

access-list AnyConnect-Redirect extended deny udp any any eq domain
access-list AnyConnect-Redirect extended deny udp any eq bootpc any eq bootps
access-list AnyConnect-Redirect extended deny udp any host 10.1.2.95 eq 8905
access-list AnyConnect-Redirect extended deny tcp any host 10.1.2.95 eq 8905
access-list AnyConnect-Redirect extended deny udp any host 10.1.2.95 eq 8909
access-list AnyConnect-Redirect extended deny tcp any host 10.1.2.95 eq 8909
access-list AnyConnect-Redirect extended deny tcp any host 10.1.2.95 eq 8443
access-list AnyConnect-Redirect extended permit ip any any 

### 10.1.2.95 is the ISE server

hslai
Cisco Employee
Cisco Employee

Adding to Mike.Cifelli...

Please check the DNS servers configured for the RA-VPN clients. Then, ensure the DNS queries and responses will go through to the internal DNS servers either as Mike.Cifelli suggested or use DACL or interface ACL to permit that.