05-03-2013 02:23 PM - edited 03-10-2019 08:23 PM
Hi all,
Can any one help me in configuration of ISE in inline posture mode. and What are the limitation of this mode.
Solved! Go to Solution.
05-03-2013 02:35 PM
The following are known limitations for Inline Posture in Cisco ISE, Release 1.0.
• Inline Posture is not supported in a virtual environment, such as VMware.
• Backup and restore is not available for Inline Posture nodes in Cisco ISE, Release 1.0.
• The Simple Network Management Protocol (SNMP) Agent is not supported by Inline Posture.
• The Cisco Discovery Protocol (CDP) is not supported by Inline Posture.
For more information over configuration and others you can see the attached PDF
05-03-2013 02:35 PM
The following are known limitations for Inline Posture in Cisco ISE, Release 1.0.
• Inline Posture is not supported in a virtual environment, such as VMware.
• Backup and restore is not available for Inline Posture nodes in Cisco ISE, Release 1.0.
• The Simple Network Management Protocol (SNMP) Agent is not supported by Inline Posture.
• The Cisco Discovery Protocol (CDP) is not supported by Inline Posture.
For more information over configuration and others you can see the attached PDF
05-04-2013 10:53 AM
Thank you very much Ravi. I was looking for the same document. It realy worked for me.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide