ISE power Supplies check

[armina.emad1]

I have ISE appliance with dual Power Supplies is there any way CLI or GUI to check if there is a failure in any one of them ? 

[andrewswanson · Accepted solution]

Hi

The appliance CIMC is the tool to use for this.

hth

Andy

[Arne Bier]

Here from CIMC - CLI will of course give same result

[Damien Miller]

I would like someone to attempt to monitor a physical SNS ISE appliance with Cisco Intersight. I do not have any available to me to try this with. While there is no support stated for non UCS SKU's, SNS appliances are after all just UCS C220's under the label. The free version provides remote hardware monitoring relaying on the CIMC 3.0(4)+ software. If it doesn't work, it would be a great feature request for a free(limited features) UCS management platform.