ISE question regrding ISR1000 series router ( C1111-4PLTEEA ) IOS-XE Everest 16.6.7

[ade5]

Good morning ,

I do not see the "ip device tracking" command when configuring this ISR router . Is the "ip device tracking" command old and being replaced in this ios version ? 

What is the alternative configuration so that the ISR router will send ip address information to ISE on this router ? 

thanks

[howon]

We have not gone through compatibility work with ISR 1000 & ISE. What use case are you trying and is this for wireless or wired?

[Alejandro Rodriguez]

I have the same problem.

I triying for wired.

[Greg Gibbs · Accepted solution]

I'm not sure if the feature is available for the ISR1000, but check if the SISF-based Device Tracking feature for Everest code on the Cat3850 is available in the command structure on the ISR.

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3850/software/release/16-6/configuration_guide/sec/b_166_sec_3850_cg/configuring_sisf_based_device_tracking.html

As @howon mentioned, however,  the ISR1000 has not been tested/validated against any current version of ISE.

[Alejandro Rodriguez]

Thanks four your reply.

SISF-based Device Tracking, is not Support on ISR 1100.