Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello
I need to configure flexible netflow in L3 port-channel interface at WS-C3850-12XS IOS Version 16.3.3, but it,s not possible.
MG_CORE(config-if)#ip flow monitor Netflow-Monitor-In input
% Flow Monitor: Failed to add monitor to interface: flexi...
Hello
I have a Websense and Cisco router.
I will use WCCP to redirect traffic https on port tcp 91
I configured WCCP service number 70, but the traffic non redirects.
Whera are the problem?
Thansk
Buen díaTengo un router 7600 con dos WAVE 694, configurados por WCCP y metodo MASK Quiero que esten en load-balancing.Pero solo hay trafico rederigido a un wave.La topología de la red es con sucursales /24 y un centro de computos /16Ambos WAVE deben ...
Reza Sharifi , 2rcluett
I have change the source interface to Ten1/0/10, but the problem persist
MG_CORE#sh flow monitor Netflow-Monitor-In statistics Cache type: Normal (Platform cache) Cache size: Unknown Current entries: 0
Flows added: 0 Flows a...
I have configured Netflow in the port TE1/0/10 and TE2/0/10, but Netflow are not working.
This is the configuration.
!flow record Netflow-In match flow direction match interface input match ipv4 destination address match ipv4 protocol match ipv4 sour...
