ISE SNS 3715 use of 10G Fibre Interfaces

[girish_gavandi]

Hello,

I have a new ISE SNS-3715 server appliance. I want to use the onboard 10G fibre interfaces. By default, while initializing ISE, it took the 10G UTP interfaces and came up. How do I switch to 10G fibre interfaces (Gig 2 and Gig 3).

I am running ISE version 3.2 with patch4.

Any help is much appreciated.

Regards,

Girish

[Rob Ingram · Accepted solution]

@girish_gavandi eth0 must be used for ISE management, you can also use a separate interface for RADIUS/TACACS etc. You'd require static routes via the other interface's next hop.

https://community.cisco.com/t5/network-access-control/ise-multiple-interfaces-for-management-tacacs-radius-guest/td-p/3458926