- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2018 12:29 AM
Hi,
In WLC 8.6, we started supporting volume metering by allowing radius accounting interim interval to be set at a granular 60 seconds level.
config wlan radius_server acct interim-update interval
With this said, is there a way to setup ISE to disconnect (CoA) a guest user when he has downloaded more than xMB of data (e.g. 500MB)?
I know we can do this with CMX Engage/Connect, WLC sent radius accounting to Freeradius Lite which is bundled with CMX.
Note: I'm referring to data usage and not bandwidth contract.
Thanks.
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2018 04:24 AM
This is not yet supported with ISE.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2018 04:24 AM
This is not yet supported with ISE.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2018 07:56 AM
As Hosuk stated it’s not supported , please reach out to the ISE product manager thru sales channel to request the feature

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2018 03:51 PM
I think this would be the best feature of the century. If I had a dollar for every customer who asked for this ... it gets my vote.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2018 03:58 PM
Please get your info to the PMs
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-03-2018 10:14 PM
I think this Community forum should be the vehicle for that.
I always wondered why the ISE PM(s) don't lurk on these forums. They can ignore all the operational reactive stuff if they don't have time and just focus on what fishing out potential product enhancement requests.
There are not THAT many postings here to swamp them. If I can read every single one of them (because I am using the RSS feed into my Outlook client, so that I never miss anything) then I am sure they could do the same.
Alternatively, I think we should start using hash tags and then someone at Cisco can filter out the hash tags to gauge the sentiment of the customer base.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-06-2018 07:58 PM
I concur with Arne. We should be collecting features requested from the Field into a smart-sheet.
