10-14-2021 06:01 AM
Hi all,
I am trying to find the Stage option when adding a Network Device, however I can not see it in the GUI of SIE 3.0
The Stage: Monitoring option is what I am looking for. Any Idea if it was removed to another concept, as in previous version, it was available in the Add New Network Device option.
Please find the image attached for more clarification of what I am looking for, but unable to find in the ISE 3.0 version.
Thank you,
Laura
Solved! Go to Solution.
10-14-2021 06:16 AM
Hi @laurathaqi
I don't think that is built in to ISE 3.0, you just need to create a Network Device Group called "Stage" and sub-groups for the Monitor, Closed and Low-Impact modes.
10-14-2021 06:23 AM
Hi @laurathaqi ,
at Administration > Network Resources > Network Device Groups, Add the following:
After that, you are able to check the Stage at Administration > Network Resources > Network Devices.
Hope this helps !!!
10-14-2021 06:16 AM
Hi @laurathaqi
I don't think that is built in to ISE 3.0, you just need to create a Network Device Group called "Stage" and sub-groups for the Monitor, Closed and Low-Impact modes.
10-14-2021 06:23 AM
Hi @laurathaqi ,
at Administration > Network Resources > Network Device Groups, Add the following:
After that, you are able to check the Stage at Administration > Network Resources > Network Devices.
Hope this helps !!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide