old switches and ISE 3 compatibility

[baselzind]

currently most of my switches are WS-C3560V2-48PS , do they support ISE 3 to authenticate users through 802.1X ?

[Mark Elsen]

          - FYI : https://www.cisco.com/c/en/us/td/docs/security/ise/3-0/compatibility_doc/b_ise_sdt_30.html

 M.

[Rob Ingram]

@baselzind yes, in short if the switch supports RADIUS they should work with ISE. Bear in mind older switches may not support other features such as Change of Authorisation (CoA), Device Sensor (for profiling etc) - use the link already provided.

[balaji.bandi]

Sure 802.1x  authentication is supported and follows the below guide to configure.

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3560/software/release/12-2_55_se/configuration/guide/3560_scg/sw8021x.html

[ahollifield · Accepted solution]

https://cs.co/ise-my-nads