05-09-2015 11:26 PM - edited 03-10-2019 10:43 PM
Hi, Im currently running ACS 5.2 on Vmware with 600GB with 4G RAM ,
I have problem on access GUI once I have setup my installation in the first stage.
Im able to ping its NIC - int g0
I have several things and solution to solve it,
- I have renew http certificate by renewing IP address on the interface
- I have resize of capacity, and memory,
etc
I have no clue , I can see that traffic is reachable, I can see that there is no restriction between those two, Im guessing its about the vmware and gns3 integration.
thanks
05-10-2015 12:29 AM
Hi Terry,
Yo may be run acs start <service> in your acs console.
05-10-2015 12:54 AM
Hi,
Check if the services have come up
show application status acs
to see all the services are up or not...
05-15-2015 05:47 PM
Hi,
I can see that application status on acs's are running. and all web interfaces are enable
Is this need to be connect with DNS or something?
05-19-2015 01:38 AM
you should be able to access via web without DNS. Check your internet settings, you might be having the proxy.
05-11-2015 07:20 AM
Hi Terry,
Please see below instructions.
1. as mention by Nitesh, please use this command " show app stat acs " and make sure that the service is running for the " management process "
2. next is to try to stop and start the ACS again via cli/console.
Regards,
Chris
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide