port-security configuration on port-channel/etherchannel

[suranjan]

Is it possible/feasible to configure port-security on the port-channel/EtherChannel configured interface? If not why or if possible what's the procedure?

[Kasun Bandara]

etherchannels cannot configure with port security

[balaji.bandi]

what kind of port security are you considering here?

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst6500/ios/12-2SXF/native/configuration/guide/swcg/port_sec.html#wp1070356

[MHM Cisco World]

https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst4500/XE3-6-0E/15-22E/configuration/guide/xe-360-config/port_sec.html

The allow of port-seucirty on ether channel is depend on SW some support other not.
this guide show you it support for Cat4000 series. 

[Mike.Cifelli]

Is it possible/feasible to configure port-security on the port-channel/EtherChannel configured interface? If not why or if possible what's the procedure?

-Not sure the desire here.  Port sec is typically for access ports if unable to secure the ports via 802.1x.  Are there other mechanisms in place: perhaps the switch/es are in a locked TR/enclosure?