
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2017 12:48 PM
I have this 8-node deployment running 2.1p3 still. For both MnT, it’s on its own 3595, showing in-sync, green check mark, all that. However, on the PAN home page, system health, only the secondary MnT is showing the memory and cpu usage, the primary MnT just shows nothing, but the flat line. Is this normal?
Solved! Go to Solution.
- Labels:
-
Identity Services Engine (ISE)
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-26-2017 06:50 AM
Engaging TAC... thanks for the info.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-25-2017 07:28 PM
Are other ISE (non-MnT) nodes showing CPU/memory utilization?
Try running the report "Health Summary" under Operations > Reports > Diagnostics.
And, verify the localStore log via ISE admin CLI @ your primary MnT code:
show logging application localStore/iseLocalStore.log | inc SysStatsUtilizationCpu

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-26-2017 06:50 AM
Engaging TAC... thanks for the info.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-26-2017 03:05 AM
This does not look right,
Please also engage TAC to troubleshoot this
Thanks,
Nidhi

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-26-2017 06:51 AM
engaging TAC...thanks.

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-26-2017 09:07 AM
Have you tried a manual Sync on the Deployment page for that node. ? You might have to wait for sometime after that.
