restoration from physical to VM ( license )
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-15-2015 01:00 PM - edited 03-10-2019 11:03 PM
hey all,
is it possible to restore a backup taken from a physical appliance to a VM?
if so, what about the license? i cannot import the old license since its for an appliance
am ending up with this:
- Invalid license file, UDI mismatch: Platform UDI: "ISE-VM-K9:V01:LHKA9LA", Primary UDI: "ISE-3395-K9:v01:XXXxxxx"
my WM is a fresh install ( 90 days trial ) but the restore changed hat
Any idea?
Thx
- Labels:
-
AAA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-16-2015 08:05 AM
If you are actually moving your ise solution, you are allowed to go to cisco.com/go/license and re-host your ise licenses to a new platform/serial.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-16-2015 10:15 AM
Thx Jan,
the goal of the exercise is to replicate client config ( with backup ) in lab ( VM )then proceed to upgrade 1.1 to 1.4
hopefully, the VM vs Appliance wont show much difference in the problems i could encounter when am ready to actually upgrade client's appliances
