Show NTP ACS version 5.1

[ricardorojas123]

In the output of the show ntp in the ACS v5.1, What is the succesfull output of the show ntp ? I have the following output, the first show GPS and the second INIT

acs/admin# show ntp
Primary NTP   : 200.54.X.X

synchronised to NTP server (200.54.X.X) at stratum 2
   time correct to within 25 ms
   polling server every 64 s

     remote           refid      st t when poll reach   delay   offset  jitter
==============================================================================
127.127.1.0     LOCAL(0)        10 l   50   64  377    0.000    0.000   0.001
*200.54.X.X        .GPS.            1 u   57   64  377   32.320   11.092   5.510

Warning: Output results may conflict during periods of changing synchronization.

acs/admin(config)# do show ntp
Primary NTP   : 10.39.X.X

synchronised to local net at stratum 11
   time correct to within 12 ms
   polling server every 128 s

     remote           refid      st t when poll reach   delay   offset  jitter
==============================================================================
*127.127.1.0     LOCAL(0)        10 l   24   64  377    0.000    0.000   0.001
10.39.X.X          .INIT.          16 u    -   64    0    0.000    0.000 4000.00

Warning: Output results may conflict during periods of changing synchronization.

[Scott Fella]

This is what my output is from my lab setup:

ciscoacs1/acsadmin# sh ntp
Primary NTP   : time.nist.gov

synchronised to local net at stratum 11
   time correct to within 12 ms
   polling server every 1024 s

     remote           refid      st t when poll reach   delay   offset  jitter
==============================================================================
*127.127.1.0     LOCAL(0)        10 l   41   64  377    0.000    0.000   0.001
192.43.244.18   .ACTS.           1 u    7 1024  377   50.375  3261463 3261463

Warning: Output results may conflict during periods of changing synchronization.

[Vinay Sharma]

This is a AAA related question, so moving it to AAA community.

Vinay