11-17-2010 03:53 PM - edited 03-10-2019 05:35 PM
I am looking for documentation for setting up WCS controllers to use TACACS+ authentication. The current controllers are using TACACS+ authentication but we have two new controllers that we want to setup to use TACACS+. Tried to add the TACACS+ autentication and authorization but it does not work. Someone else set up the current controllers. Running 6.x WCS.
Solved! Go to Solution.
11-17-2010 11:47 PM
Hi,
I understand that you are talking about WLC (controller) and not WCS (Management software).
Configuring tacacs+ on wlc : http://www.cisco.com/en/US/docs/wireless/controller/6.0/configuration/guide/c60sol.html#wp1697872
Hope this helps.
Nicolas
===
don't forget to rate answers that you find useful
11-17-2010 11:47 PM
Hi,
I understand that you are talking about WLC (controller) and not WCS (Management software).
Configuring tacacs+ on wlc : http://www.cisco.com/en/US/docs/wireless/controller/6.0/configuration/guide/c60sol.html#wp1697872
Hope this helps.
Nicolas
===
don't forget to rate answers that you find useful
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: