TrustSec setup in ISE vs ASA

[FredrikW73]

If I define a new device in the ISE, for an ASA firewall, there is a

password field under Advanced TrustSec Settings / Device Authentication Settings.

Where is this password supposed to be entered in the ASA?

[andrewswanson · Accepted solution]

Hi
This password isn't used/supported on the ASA - see below for Cisco documentation.
hth
Andy

https://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise-networks/trustsec/configuration-guide.pdf

This password is not used because ASA supports only OOB PAC provisioning.
However it needs to be a valid and non-empty string in order to save the NAD object.